This kit are included all the electronics parts you need for 3D printer Kossel Mini Rostock Delta (except power supply, which you can use PC ATX power), so after you purchase this kit, then can start your project right away, no need to worry about what might be missing again. The parts we selected are all with very good quality, also we provide support while you are building it, if you have questions, please feel free to send us an email, we will also help you to complete the project !
Below are the details of parts, please read carefully, because there are many other sellers might sell you the bad and cheap quality, and cause you the whole system crash, wrong wiring is possible to burn all the parts , so please be careful while using it ! (especially the bowden hot-end and extruder cold-end)
RAMPS 1.4- http://www.amazon.co.uk/gp/product/B00JU41GQ4
Mega 2560- http://www.amazon.co.uk/gp/product/B00GRJ2A6A
LCD 2004- http://www.amazon.co.uk/gp/product/B00K6KCYEE
Kossel Extruder- http://www.amazon.co.uk/dp/B011QCFGPO
Kossel Heatbed- http://www.amazon.co.uk/dp/B011MWF3QU
Package List :
(1) 1x 3D Printer Controller Ramps 1.4 Board
(2) 1x Arduino-Compatible Mega 2560 R3 + USB Cable
(3) 5x A4988 StepStick Stepper Motor Driver Module
(4) 1x LCD 2004 Smart Display Controller + Smart Adapter
(5) 1x All Metal MK8 Extruder & Bowden hotend + 40x40x10mm fan
(6) 3x NEMA 17 Motor
(7) 1x Round MK3 Heatbed + thermistor and wire
(8) 6x Mechanical Endstop + Cable
(9) 2x 30cm Ribbon Cable
(10) 1x 40pin Dupont cable 200mm Male to Female
(11) Filament (few for test)
- (1) We use well-designed Kossel MK8 extruder, high quality stepper motor and direct drive extrusion wheel, more accurate, quick heating and fluent injection, We have made necessary design, Printing speed up to 100mm/s.
- (2) We use the latest MK3 Heatbed Round 3mm Aluminium PCB Board, dual power supply, operate at 12V or 24V. Heated bed keeps a certain temperature to prevent warping, and cooling fan speeds up solidification of the extruded filament. this would reduct your calibration time a lot !
- (3) We offer LCD 2004 controller with SD card design support totally off-line print, no computer needed while printing. then you don’t have to spare one computer for your 3D printer use only.
- (4) We have pre-install the 3D printer firmware for you . so even you know nothing about firmware , you can still get it working .
- (5) We don’t just sell them, we also provide good after-sales service, so welcome to discuss with us, we will try to do technical support as much as we can, please feel free to send us an email, we will also help you to complete the project !
Click Here For More Information